To earn your Cisco CCNA and CCNP certifications, you've got to master ISDN - and despite what some folks say, there is nevertheless a lot of ISDN out there that needs to be supported. And when it comes to troubleshooting ISDN, there's a lot to look at the guide to group policy software . Is the correct ISDN switchtype configured? Are the dialer map statements appropriate? What about the dialer-group and dialer-list commands? And that is just the commence.

I often say that all troubleshooting starts at Layer 1, the Physical layer of the OSI model. The usual approach of troubleshooting ISDN is sending pings across the hyperlink, but the connection can be tested with out employing pings or even prior to assigning IP addresses to the BRI interfaces!

It's a excellent concept to location these test calls before configuring the interfaces - that way, you know you've got a valid connection ahead of starting the configuration (and there is a lot of config to go along with ISDN!)

To place a test get in touch with with no utilizing pings, use the isdn get in touch with interface command.

R1#isdn get in touch with interface bri0 8358662

R1#

03:54:43: BR0 DDR: Attempting to dial 8358662

03:54:43: %Hyperlink-three-UPDOWN: Interface BRI0:1, changed state to up

03:54:44: BR0:1 DDR: dialer protocol up

03:54:45: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state to up

03:54:49: %ISDN-6-CONNECT: Interface BRI0:1 is now connected to 8358662 R2

To tear the test call down correctly, use isdn disconnect interface <a href=“http://www.facebook.com/SDMSoftware”>official website</a> . IOS Help displays the choices with this command.

R1#isdn disconnect interface bri ?

all Disconnect the data call(s) on all b channels

b1 Disconnect the information contact on b1 channel

b2 Disconnect the data get in touch with on b2 channel

R1#isdn disconnect interface bri all

03:58:36: BR0:1 DDR: disconnecting get in touch with

03:58:36: BR0:2 DDR: disconnecting call

03:58:36: %ISDN-six-DISCONNECT: Interface BRI0:1 disconnected from 8358662

R2, contact lasted 20 seconds

03:58:36: %Hyperlink-three-UPDOWN: Interface BRI0:1, changed state to down

03:58:36: BR0:1 DDR: disconnecting call

03:58:37: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state to down

I say ” properly” simply because the 1 point you never want to do to end an ISDN get in touch with, test or otherwise, is just shut the interface. Telcos don't like it, and ISDN lab devices like it even much less group policy tools reviews . Often let the d-channel do its perform and tear the contact down in an orderly fashion - do not just cut it off by shutting the interface down.SDM Software, Inc. 2100 4th St, #132 San Rafael, CA 94901 (415) 670-9302 http://sdmsoftware.com

cisco_ccna_ccnp_exam_tutorial/testing_isdn_links_without_having_pings.txt · 最終更新: 2013/05/30 12:08 by rich41